Loaded Car Subwoofers

Audison APBX 8DS Prima Series 8 4? DVC Sealed Subwoofer Enclosure System

Audison APBX 8DS Prima Series 8 4? DVC Sealed Subwoofer Enclosure System
Audison APBX 8DS Prima Series 8 4? DVC Sealed Subwoofer Enclosure System
Audison APBX 8DS Prima Series 8 4? DVC Sealed Subwoofer Enclosure System

Audison APBX 8DS Prima Series 8 4? DVC Sealed Subwoofer Enclosure System
APBX 8 DS - SUB BOX SEALED 200mm 4+4Ohm The APBX 8 DS loaded enclosure provides the highest performance/ size ratio. For this purpose an 8.5 lt. Sealed enclosure with a 4+4 O dual voice-coil configuration was adopted to exploit the full power of an AP5.9 bit (paralleling voice coils for a 2-ohm load) or with two pairs of AP8.9 bit bridged channels (one bridged pair of channels to each voice coil). The speaker's high excursion capability allows the use of the proprietary BASS BOOST of AP bit amplifiers to make use of all the available power for rich and dynamic bass. Ultra-low profile 5.16 in. / 131 mm box with sealed design perfectly tuned to fully exploit the APS 8 D driver.

2S² (2 Sides/2 Sounds) design provides the ability to choose b. Audison APBX 8DS Prima Series 8 4O DVC Sealed Subwoofer Enclosure System.

Impedance: 4 O + 4 O. Magnet: High Density Flux Ferrite. 2S² (2 Sides/2 Sounds) design provides the ability to choose between Down-Firing mounting to increase the low-frequency extension and Up-Firing install to obtain more punch and definition. Leveling feet with velcro inserts included for a secure grip with the carpet while maintaining easy removal. SSP (Sub Smart Plug) features both traditional push contacts and a Plug-&-Play terminal block to easily configure the impedance as required and provides a quick release. Rounded corners allow easy positioning in the trunk and act as reinforcement to reduce enclosure resonance. Special designed cone-dustcap-basket geometry which guarantees a long linear excursion capability (9 mm, one-way). Massive driver motor assembly, optimized with FEM (Finite Element Modeling) for perfect control under high excursion conditions.

Water-repellent pressed paper 8 in. Cone, featuring a profile developed with FEM simulation and optimized with the Klippel Scan Vibrometer. Specifically developed to be combined with either AP1 D mono or AP4.9 bit/AP4 D (2 CH bridged) amplifiers taking advantage of the bass boost feature and integrated parametric equalizer of the built-in DSP. This item is in the category "Consumer Electronics\Vehicle Electronics & GPS\Car Audio\Car Subwoofers". The seller is "creative-car-audio" and is located in this country: US.

This item can be shipped to United States.
  • Brand: Audison
  • MPN: 69035010
  • Type: Loaded Enclosures - Single 8\
  • Model: APBX-8DS
  • bullet_point1: Power Handling: 250W Continuous Power
  • bullet_point2: Power Handling: 500W Peak Power
  • bullet_point3: Impedance: 4 Ω + 4 Ω
  • bullet_point4: Magnet: High Density Flux Ferrite
  • bullet_point5: Cone: Cotton-fiber Pressed Paper
  • UPC: 8018823119887

Audison APBX 8DS Prima Series 8 4? DVC Sealed Subwoofer Enclosure System