Loaded Car Subwoofers

Audison APBX 8R Prima Series 8 4? SVC Ported Subwoofer Enclosure System

Audison APBX 8R Prima Series 8 4? SVC Ported Subwoofer Enclosure System
Audison APBX 8R Prima Series 8 4? SVC Ported Subwoofer Enclosure System
Audison APBX 8R Prima Series 8 4? SVC Ported Subwoofer Enclosure System

Audison APBX 8R Prima Series 8 4? SVC Ported Subwoofer Enclosure System

APBX 8 R - REFLEX SUB BOX 200mm 4Ohm The APBX 8 R loaded enclosure was developed with reflex loading, with tuning designed to concentrate SPL in the lowest frequency range. The aim was to exploit the natural boost in output found in most cars below 60 Hz known as "cabin gain". The 8-inch single 4 O voice-coil subwoofer has a powerful motor that maximizes efficiency in combination with the AP8.9 bit amplifier. The low-resonant frequency of the subwoofer, matched to the reflex enclosure keeps excursion low within the entire audio spectrum, allowing also the use with a pair of AP4.9 bit / AP4 D bridged channels, capable of delivering 260 W rms.

Ultra-low profile 5.16 in. / 131 mm box with slot-ported design perfectly tuned to fully exploit the APS 8 R d. Audison APBX 8R Prima Series 8 4O SVC Ported Subwoofer Enclosure System. Magnet: High Density Flux Ferrite. / 131 mm box with slot-ported design perfectly tuned to fully exploit the APS 8 R driver. 2S² (2 Sides/2 Sounds) design provides the ability to choose between Down-Firing mounting to increase the low-frequency extension and Up-Firing install to obtain more punch and definition. Levelling feet with velcro inserts included for a secure grip with the carpet while maintaining easy removal. SSP (Sub Smart Plug) features both traditional push contacts and a Plug-&-Play terminal block to easily configure the impedance as required and provides a quick release.

Rounded corners allow easy positioning in the trunk and act as reinforcement to reduce enclosure resonance. Special designed cone-dustcap-basket geometry which guarantees a long linear excursion capability (9 mm, one-way). Massive driver motor assembly, optimized with FEM (Finite Element Modeling) for perfect control under high excursion conditions. Water-repellent pressed paper 8 in.

Cone, featuring a profile developed with FEM and optimized with the Klippel Scan Vibrometer. Specifically developed to be combined with either the AP8.9 bit (2 CH bridged) or AP4.9 bit /AP4 D (2 CH bridged) amplifiers taking advantage of the bass boost feature and integrated parametric equalizer of the built-in DSP. This item is in the category "Consumer Electronics\Vehicle Electronics & GPS\Car Audio\Car Subwoofers". The seller is "creative-car-audio" and is located in this country: US. This item can be shipped to United States.
  • Brand: Audison
  • MPN: 69035020
  • Type: Loaded Enclosures - Single 8\
  • Model: APBX-8R
  • bullet_point1: Power Handling: 250W Continuous Power
  • bullet_point2: Power Handling: 500W Peak Power
  • bullet_point3: Impedance: 4 Ohms
  • bullet_point4: Magnet: High Density Flux Ferrite
  • bullet_point5: Cone: Cotton-fiber Pressed Paper
  • UPC: 8018823119894

Audison APBX 8R Prima Series 8 4? SVC Ported Subwoofer Enclosure System